Brey Krause Seat Back Brace Bracket - Weld-On 1.75" Bar Category_Side Mount Brackets The Brey-Krause Harness Mounts support

The Brey-Krause Harness Mounts support the loads specified by the National Highway Traffic Safety Admin

Flat seam and interlock wave construction eliminate pressure points during long stints in the car

This mounting bracket is secured by welding to the roll bar tubing

The mount does not interfere with the factory seat-belt

1m long cable ends in a 4-pin 712-male cable end

Brey Krause Seat Back Brace Bracket - Weld-On 1.75" Bar Category_Side Mount Brackets The Brey-Krause Harness Mounts supportThe Brey Krause R 9022 Seat Back Brace Bracket is welded directly to a 1. 75" diameter tube as an attachment point for the Brey Krause R 9019 9020 Seat Back Braces. This mounting bracket is secured by welding to the roll bar tubing. Once welded to the roll bar, the seat brace can be adjusted fore, aft, up or down. The mounting bracket is fabricated from Type 304 stainless steel. Note: This bracket must be installed by a certified welder.